Top numbers should be at least 4" thick and 24" high. Numbers on the sides of the racecar should be in contrasting color from the body and be at least 4" – All racecars must be numbered with large legible numbers on both sides, on top and on the nose. Wider than the body on each side and may not be open-ended – Rear bumpers may be constructed of tubing or flat stock. – Rear bumpers and side rail bars must not extend beyond the width of the rear tires. One and 1 1/4" tubing and must be able to support the racecar if lifted by a tow vehicle. Must be mounted with the bottom loop parallel to ground. – Both front and rear bumpers must be used, and must not have any sharp edges. – Center of bumpers (front and rear) must be at least 16" from the ground and no more than 20" from – Skirts and/or engine covers are not allowed. – Excluding the hood and nose piece, the top body may extend no further forward than the back of theĮngine block, and the bottom no further forward than 6". – Spoiler supports may be a maximum 15" long, maximum 2" tall at front and maximum 6" tall at back,Īnd may not exceed 6" tall for more than one-half of the overall length of the spoiler support. – Maximum 5" spoiler is permitted with a maximum of 2 center supports and 2 side supports. – Bodies with excessive damage (as determined by an official) will not be allowed to compete. – Panel(s) in front of the right door next to the engine compartment are not allowed. A belly pan will be defined as any object or material that alters the airflow under – Hood may be no more than 2" above decking. Maximum 5" tall at rear of decking and must remain separate from rear spoiler and spoiler supports. – Sail panels may have no more than 4" bow from top to bottom, no more than 2” bow front to back and – Sail panels must be of matching design with matching styles on both sides of racecar. Than 1.5" stiffener allowed at the rear of the roof and must turn down perpendicular to the ground. – Original roof line of vehicle must be maintained with a maximum of 5" of slope from rear to front. – A minimum window opening of 12” must be maintained on all four window openings (front, back, left and – Stock appearing front window support units must be used (painted roll bars are not acceptable substitutes). – An aluminum half-windshield may be used on driver's side front window opening only. – 1970 or newer American compact passenger car only (no panel vans or station wagons). Any interpretation of the rules is left to the discretion of the officials. No expressed or implied warranty of safety shall result from such alternation of specifications. The race director shall be empowered to permit reasonable and appropriate deviation from any of the specifications herein or impose any further restrictions that in his/her opinion do not alter the minimum acceptable requirements. They are intended as a guide for the conduct of the sport and are in no way a guarantee against injury or death to a participant, spectator, or official. No expressed or implied warranty of safety shall result from publications of or compliance with these rules and/or regulations. These rules shall govern the condition of all events, and by participating in these events, all participants are deemed to have complied with these rules. The rules and/or regulations set forth herein are designed to provide for the orderly conduct of racing events and to establish minimum acceptable requirements for such events.
0 Comments
Leave a Reply. |